Tactical, combat, military, law enforcement and home defense use of a Remington 870 shotgun.
4 posts • Page 1 of 1
Some sources claim an 870 mag extension (two shot) will work on an older Remington Model 11. Yet,info.from manufacturers say the two are incompatible. Magazine tubes seem very similar to me,and end caps interchange. Except for Model 11 cap is thicker,and threads down further to secure barrel/forend. Suspect threads don't extend far enough into the extension to accomplish this. Would an appropriate size spacer bushing in between suffice? Would a two piece extension be better,or would there be too few threads left for extension tube. Realize this isn't 870 specifically,but more 870 related (sort of)... I'd like to do this,but don't want to buy a product that isn't going to work on my "off-label" application. Appreciate any replies from any who own both models,and/or anyone that knows,or who's done this...
- Senior Shotgunner
- Posts: 298
- Joined: Thu Nov 29, 2012 9:35 pm
- Location: Lost State of Franklin
The model 11 cap will fit on my 870,I use one when I use a 13 inch barrel on one of my SBS, L like how it looks. I also found out the model 11 cap will fit on my Mossberg Shockwave, but the detents do not line up. As for working on a model 11, I don't have one to test.
The devil danced as he went down, in the hail of arrows comin' Out on the wild Montana ground, Custer died a-runnin'.
- Elite Shotgunner
- Posts: 3022
- Joined: Fri Dec 28, 2012 8:04 am
- Location: The Inland Northwest
If I recall correctly, the Model 11 is a long-recoil design with a moving barrel. 870 mag extensions are designed to stay tight against a nonmoving barrel guide ring (and in some cases, be clamped to the barrel itself). Even if the thread matches, I'm not sure you'll get reliable function putting an 870 extension on a Model 11,
Threads are the same. You need to make a .250 (1/4") spacer to take up the extra length. You can make it out of whatever metal you have, I have seen some make them from PVC, but any steel, aluminum, brass will work. I have a Tac-Star 5 shot extension on a 30" barreled Remington 11 and it works fine. Poor mans 3 gun.
Who is online
Users browsing this forum: No registered users and 0 guests