S&J Hardware Shotgun Follower
Last weekend I have tested S&J Hardware Shotgun Follower. I have made about 250 shots and didn’t have any malfunctions.
S&J Hardware Follower for Remington 870 Shotgun
This shotgun follower is the best I have ever used. Let me start with advantages it gives to a shotgun owner:
1. Bright orange (close to red) color.
2. Tail which prevents spring from kinking and improves feeding.
3. Allows to check an empty shotgun magazine by your finger.
4. It has slots in the sides so it can be used in the Remington Express and other non-Police models (which have dimples in magazine tube).
5. Followers are CNC machined from 2″ thick piece of DuPont Delrin® material. Which is a type of teflon impregnated plastic. Delrin is hard enough to machine, soft enough for use and very slippy. So its ideal for a shotgun follower.
This follower is not hollow inside and doesn’t have weak points (like Scattergun follower). It will not break down with cleaning products and hard use. I was looking for a such follower for a very long time.
I highly recommend to use this follower and think that this follower is the best on the market.
Spread The Love, Share Our Article
Comments
Trackbacks
There are no trackbacks on this entry.
Good choice! I have never read a bad review about S&J’s followers. they have a lot of other nice products also.
Where are these available?
Hi Bill,
They are available here: http://sjhardware.com/
Vitaly.
This follower did not work with my factory extension and spring. It would only allow me to load 4 rounds before it got stuck. I tried everything I could think of to make it work since I like it so much but had to switch back to the factory follower which works every time. The Remington certified armorer from AI&P that sold me my factory 18.5″ barrel and factory extension informed me that he and a few of his clients also could not get the S&J follower to work reliably with the factory extension and spring. I may try to the Nordic aluminum follower to see if it works.